Diesel Place banner
1 - 7 of 7 Posts

· Registered
Joined
·
3,391 Posts

· Registered
Joined
·
259 Posts
Don't know if you have an lly or lb7, Don't know if it matters, I have an lb7. The worst connection is on page 8, pics 22 and 23,(Thanks Bodysurfer)of the directions. The part of the stock connector you must press, (lock/clip?), to release it, is down, you cannot move the connector to make it easier to depress the little lock/clip for removal. I could not get my hand in there to press the lock/clip, and pull apart the connector at the same time. What I did was this, you know the lock/pin that holds our headlights in? I removed that and used it to get under the lock/clip, pull up, while pushing down on the top of the connector at the same time,and wiggling it apart. Confused? Me too after reading this! But when you get it, read this and the directions over and over and it's a whole lot easier than I sound/write. Good luck.
 

· Registered
Joined
·
401 Posts
Yup, use a long screw driver or something similar that you can get underneath the connector. If you can get that, the rest is pretty easy.

Jon
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top