Diesel Place banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,368 Posts
Discussion Starter · #1 ·
i see the ability to adjust things based on differant baro, or maf or ect. my question is say in b2201 boost control baro map a, the value in the parameter is 10.2 psi, the description says
"Defines the barometric pressure value above which all (C) boost control tables will be used."

now this is anytime the baro is above 10.2 it used this table? if so i am confused then why you need the next to boost/baro tables because they only use a higher psi number. but if they are already adjusting to a higher psi than 10.2.

simply why do you need three baro charts if you just make your adjustments in the lowest one it will cover all the rest just because the baro is already higher than the lowest parameter. i hope you under stand my intent here.
 
1 - 1 of 1 Posts
Top