Diesel Place banner
1 - 5 of 5 Posts

·
Registered
Joined
·
456 Posts
Discussion Starter · #1 ·
K, so I was washing my truck and noticed that it appears like a spring isolator or whatever they are called has slipped partially out one of my deaver spring packs. Picture shows it, just pinched in there on the inside of the spring (towards the frame). This probably happened a few weeks ago while I was hunting along the Calif/Nev border, rough steep road with waterbars all over it. I am assuming I can just jack one side up and let this side sag so I can just slip the isolater back in. Am I right? Any easier ways?
 

Attachments

·
Registered
Joined
·
5,202 Posts
I think they snap into a hole in the spring
 

·
Registered
Joined
·
456 Posts
Discussion Starter · #3 ·
Yah i think you are right. I tried jacking one side and letting this side sag, I was able to tap it in a little but not all the way. I don't think I have a tall enough jack and or combination of jacks to get this to work.
 

·
Registered
Joined
·
1,076 Posts
Loosen the leaf clamp right above it, and than jack it up. It may give you enough from to get it in there.
 
1 - 5 of 5 Posts
Top