cranking torsion bars vs. torsion bar keys?

3381 Views 5 Replies 4 Participants Last post by _nar_, Feb 2, 2007

sdc

Discussion Starter · Jan 30, 2007

Have a 02 gmc diesel with a 6 inch rcd lift. The front seems a little lower than rear. Was wondering if a 2 inch torsion bar key lift would be a good idea to level the truck? I took the torsion bar cranking method but driving in 4 wheel drive on ice and snow you can't control the truck on the road it pulls you damn near off the road. Was wondering what that lift does that is different from cranking torsion bars?

Save

1 - 3 of 6 Posts

sdc

Discussion Starter · #2 · Jan 30, 2007

sdc;1559401; said:
Have a 02 gmc diesel with a 6 inch rcd lift. The front seems a little lower than rear. Was wondering if a 2 inch torsion bar key lift would be a good idea to level the truck? I took the torsion bar cranking method but driving in 4 wheel drive on ice and snow you can't control the truck on the road it pulls you damn near off the road. Was wondering what that lift does that is different from cranking torsion bars?

yes i did have it aligned after cranking the torsion bars.

Save

sdc

Discussion Starter · #4 · Feb 2, 2007

thanx for the reply. Just wasn't sure. I still don't understand how they sell them then.

Save

1 - 3 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month