Diesel Place banner
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have a 2002 Duramax. I need to replace the clockspring. I have the airbag and steering wheel removed, but don't know how to remove the clockspring. Can anyone tell me how to get it off the column. Thanks.
 

·
Registered
Joined
·
173 Posts
Here are the instructions. There is a snap ring that holds the clock spring on the column shaft. Remove that and slide it out.

1: Disable the SIR system.
2:Remove the steering column trim covers. Remove the wire harness assembly out of the wire harness strap
3:Remove the 3 wire harness straps from the wire harness assembly.
4:Remove the wire harness strap from the upper tilt head assembly.
5:Remove the SIR steering wheel module coil retaining clip. 6:Remove the SIR steering wheel coil.
7:Remove the wave washer from the steering column upper shaft
 

·
Registered
Joined
·
44 Posts
hj
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top