Diesel Place banner

1 - 1 of 1 Posts

·
Registered
Joined
·
292 Posts
Discussion Starter #1 (Edited)
Just test fitting this... so far so good. Wanted the brake controller in a better place than in front of my shin, so I fabbed this up - still need to trim off the opening around the controller. The panel is formed from a piece of acrylic, and the end switches keep it tight with large (also acrylic) washers covering the lighter/charger holes. The switches are for high idle, factory engine brake and courtesy lights being wired up shortly. The CB just slid into its home underneath.
634390
 
1 - 1 of 1 Posts
Top