Diesel Place banner
1 - 1 of 1 Posts

· Registered
95 Posts
Discussion Starter · #1 ·
I am going to install some under truck lighting and found a place to use some empty bolt holes but don't know if they are standard or metric thread.

This is on a 04.5, CC,3500.
These holes are pretty much under the doors on both sides and stuck up under the rocker panel .

My thoughts are to use these holes to hold some brackets that I'm making up and attaching my LED's to the brackets.
These holes look like a course thread and I've found a bolt that will go in but not very far and before I try to tighten it and maybe screw it up (and my project ) I thought I'd ask you guys

Any thoughts?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.