Diesel Place banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
1,463 Posts
Discussion Starter #1
Did search but came up empty,exactly where should I be tapping for the boost.Very different than the LB7 I had.
 

·
Registered
Joined
·
538 Posts
I put mine in the alum tube just after it exits the turbo, about 3 inches after the blue tube connector. Seems to work very well. I stuffed a towel in the tube drilled and tapped. Then pulled out the towel and all the chips. Spread a little J/B weld on the threads to assist holding it in.
 

·
Registered
Joined
·
69 Posts
You should be reading boost after the entire system... right before the intake. That way you can detect leaks in the system, like the intercooler, joints, etc...
 

·
Registered
Joined
·
2,355 Posts
Its better to monitor right after the intercooler, this way you get the cold condinced air reading (what you want). Ill take a pic and post where i tapped mine if you'd like
 

·
Registered
Joined
·
902 Posts
I did it in the cast aluminum intake pipe before it goes into the engine.
 

·
Registered
Joined
·
10,516 Posts
bo799;1587547; said:
I did it in the cast aluminum intake pipe before it goes into the engine.
Correct Placement.
 
1 - 6 of 6 Posts
Top