Diesel Place banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter #1
ok, so i installed my intake manifold from superdiesel (thanks mike) today and i was trying it out. with my ppe hot +2 on level 4 my boost reading was approx 22 psi (can't really stare at the guage while i'm driving :eek:) . is this a normal reading? oh yeah, i also have the ppe boost valve installed too. shouldn't my boost read close to 28-30 psi or is this only on the higher settings?

anyone??
 

·
Registered
Joined
·
3,756 Posts
Programmer will not add boost. The valve should and you should be up to about 20-25. The PPE add a little but that it. The Kennedy valve with get you more by dailing it in. I would say you are okay at that reading. But, double check the clamps on the SD and check for leaks on your boost line,
 

·
Registered
Joined
·
86 Posts
Discussion Starter #3
thanks for the input. i have a banks bighead in the garage. i guess i'll take off the ppe valve and install that. maybe i can get around 28-30psi
 

·
Registered
Joined
·
86 Posts
Discussion Starter #5
nah...i think i will stay w/my ppe :D :D
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top