Diesel Place banner

1 - 8 of 8 Posts

·
Registered
Joined
·
313 Posts
Discussion Starter #1
Anyone know where i can find this on an 07 LBZ, I know its a weatherpack connector with 3 wires I believe. Thanks
 

·
Registered
Joined
·
12,036 Posts
Haven't seen a 07, but:

Undo the serpentine belt with a 1/2 breaker bar in the square on the tensioner.
Unbolt the A/C and 2 electric connectors.
Set AC unit on the pass battery.
Look to the lower right behind where the AC unit was.
 

·
Registered
Joined
·
313 Posts
Discussion Starter #3
Thanks McRat appreciate the help.
 

·
Gone but not forgotten member
Joined
·
11,313 Posts
Is this something I could use to get a boost reading for a guage?
 

·
Gone but not forgotten member
Joined
·
11,313 Posts
JD4440;1235318; said:
Is this something I could use to get a boost reading for a guage?

ANYONE ?
 

·
Registered
Joined
·
1,241 Posts
Uhh...I thought at least the 06's were on the cast manifold, very close to the intake air heater on the front left most area of the engine. You shouldn't have to take anything out to get at it. Thats where my PPE boost controller plugged in anyway.........Anyone else want to chime in?

If you are looking for a place to attach a guage...you will most likely need to tap somewhere in the aluminum around there. Thats what I did anyway for my boost guage. Search around on the forum a bit. You should find some good info on installing a boost guage in existing posts.
 

·
Registered
Joined
·
313 Posts
Discussion Starter #7
For my 05 LLY the sensor is back behind the ac unit, but on the 07 Donovan is correct for the location.

Donovan how is your boost controller working? How much psi do you see?
 

·
Gone but not forgotten member
Joined
·
11,313 Posts
Thanks donavan; I'll take a look
 
1 - 8 of 8 Posts
Top