Diesel Place banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
3,740 Posts
Discussion Starter · #1 ·
right where i installed my blocker plate I just noticed a very small pinhole leak. its just air pissing out, maybe a little oil in there too. is this a big deal. I am going to make a homemade gasket to seal the leak but was just wondering if it is a big issue. also if it is oil wheres it coming from, is it bad. I think it is just egr blowby, am i wrong?
thanks
jake
 

·
Registered
Joined
·
11,953 Posts
I would say if thereis movment of gasses(a leak) you will het hotter since the gasses arnt dead heading and you will burn through in that are eventually. Or is it leaking on the gasket or what?

I always had good luck with copper RTV on gasser headers and exhaust.
 

·
Registered
Joined
·
3,740 Posts
Discussion Starter · #3 ·
Its just where the blocker plate is installed, on the front, right below the finger hole. Im sure if I remove the plate, put some gasket maker around the edges and reinstall, the leak will be no more. Now it just needs to stop raining so I can do it.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top