Diesel Place banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,505 Posts
Doing work under the hood last week installing a pyro, I took the opportunity to unwrap the block heater cord also. I thought it was a little short myself.


I found that if you run it straight down and along the bottom of the wheelwell it will reach near the back of the foglight. Using some wire ties I attached it to some factory wiring that was in the area. Now the plug hangs down between the foglight and the inner fender liner for access through the wheelwell and front tire area.


I'd rather have it that way then swinging back and forth against the front headlights or bumper. Won't take long before the paint/plastic is stratched and marred.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top