Diesel Place banner

1 - 2 of 2 Posts

·
Registered
Joined
·
731 Posts
Discussion Starter #1
i got my new fitting to install where my bleeder screw goes so i can hook up my fuel pressure gauge , the question is do you have to put a oring or a washer on the fitting and how tight do i need to get it i put it on and it felt tight and it almost felt like it stripped b/c it got loose again, but the plastic one tightened back up right, i gona try again when it warms up, everything is froze here and i could nt get my truck into the shop to work on it, any help would be nice.
 

·
Registered
Joined
·
2,149 Posts
Mine had an oring on it when I bought it. I turned mine a hair past hand tight to tighten it. Havent had anyleaks yet.
 
1 - 2 of 2 Posts
Top