Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
515 Posts
Discussion Starter #1
Does anyone has the factory or proper bleed procedure for a new motor. All lines, rails, CPS pump empty, etc.
 

·
Premium Member
Joined
·
20,561 Posts
u00bse1;1557435; said:
Does anyone has the factory or proper bleed procedure for a new motor. All lines, rails, CPS pump empty, etc.

you dont bleed a commonrail injecton system like old diesels. Try to bleed a commonrail system that way and you will get shot in the face with anywhere from 6,000-23,000psi of diesel.:)

there is a plastic beeder screw on top of the fuel filter housing, open that and pump the hand pump 30 times or so, then close the screw, pump it another 10 times, and then start the engine.

ben
 

·
Registered
Joined
·
515 Posts
Discussion Starter #3
ok....just the same as the manual states for filter changes.

thanks.
 
1 - 3 of 3 Posts
Top