Diesel Place banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
233 Posts
Discussion Starter · #1 · (Edited)
I'm looking into a 4" MBRP cat back system for my LBZ, and like the looks of the black stainless for a tip. My preference is a longer one in black stainless, with an angle cut, dual wall...one that you wouldn't notice where it's attached.
These buggers are hard to find. At least one that I like.

How long of a tip can I use for the MBRP?
 

·
Registered
Joined
·
1,360 Posts
Good possibility. I'd be interested too.
 

·
Registered
Joined
·
2,800 Posts
We have the black chrome in a dual wall straight tip from Silverline. I will have to check on the angle / slash cut style. You do not have a lot of room for a longer tip due to the bend in the pipe.
 

·
Banned
Joined
·
3,234 Posts
RBP makes a black tip. Not sure what it's made out of though.
 

·
Registered
Joined
·
233 Posts
Discussion Starter · #5 ·
I was wondering about how much room there is under there to that bend.
I've seen some exhaust pics here on the forum that show the 12" (I think) and it looks like there is some room still. Dunno if an 18" will fit. :help2:
I'd like it to go as far as possible to avoid that bolt on look if I can

...for the replies so far...:thankyou2
 

·
Registered
Joined
·
233 Posts
Discussion Starter · #6 ·
Could someone that has the MBRP 4" please measure to see how long of a tip could fit before the bend? I think that is what would really help here...TIA
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top