Diesel Place banner
1 - 3 of 3 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
How have other dealt with the narrow space between the driver side positive battery terminal and the bracket that holds the washer reservoior? Its tight even with the stock bolt and wires :(

I was thinking of notching or cuttin a chunk out of this bracket to allow dor more space. See white mark on bracket for area of interest....


Hood Automotive tire Motor vehicle Wood Automotive design
 

·
Registered
Joined
·
71 Posts
Discussion Starter · #2 ·
I ended up cutting off the bracket to the right of the far left bolt in the picture above. I removed the two bolts holding it to the driver inner fender support and then used an angle grinder with cutoff wheel and trimmed it off.

I neglected to take a pic of the final product without the battery installed but the pic shows how much clearance I now have. Plenty of room now to connect up the newly made 1/0 cables :)

Motor vehicle Gas Auto part Metal Automotive exterior
 

·
Administrator
Joined
·
21,803 Posts
Great work!
Thanks for giving us an update

(y)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top