Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
135 Posts
Discussion Starter #1
Are they pressed in or bolted/Rivited in?
 

·
Registered
Joined
·
1,457 Posts
Depends, need more information. If you do it like GM wants on the upper, you need the whole UCA. I believe that you can press them out and back in though. I am just having the dealership change them as long as they are under warranty...after that, I will just go to the cognito leveling kit.
 

·
Registered
Joined
·
67 Posts
They are pressed in. You can rent a press from a auto supply if you plan on doing it your self. I just replaced mine. Make sure you use a sledge hammer and a fork to remove the lower ball joint from the lower control arm because its a b!t*h.
 
1 - 3 of 3 Posts
Top