[Joe E]

Got mine today, only to find out that Edge had sent Con some 4.71 units WITH the green wire attached (ie. "Attitude Ready"), only they WEREN'T! Called Edge, they said the only ones out there which can use the Attitude are the 4.73 units. A new one's on it's way (tomorrow), but the Attitude unit is slick (wish it worked).

 

[Joe E]

I'm not sure where I'm going to mount it. As Sneaks said, it comes with a pretty slick "post" to mount it, but I think it would kinda stick out (as in for thieves) where they indicate to mount it off the pillar. There is not enough wire to route to the over head console (unless you cut & splice added wire). I was thinking about routing it to the flat lower-dash to right side of the steering wheel. Not sure yet... Hopefully some people here will come up with some slick ideas once more people get them... Sorry.

 

[Joe E]

It's a 3 minute install, gsx - if it comes Friday, you'll be running it FRIDAY!

As for mounting on the dash, I might consider that. Problem is, I live in metro Detroit, and people just seem to get "curious".

 

[Joe E]

Mine actually disabled the Juice itself, had no readings from the Juice, but would go through all the functions/features, etc (it was powered up but not getting any info).





I was really upset when I couldn't tell ANY difference in performance with the Juice hooked up, and then this morning I decided to disconnect the Attitude, and WHOA!

 

[Joe E]

Yeah, but i got to drill my manifold too!!!!!!!!!!!!!!!!!

I will do the manifold this weekend. I wasn't too worried about it for my relatively short drive to work... hehe


One thing to note on the pyro, it's not "as quick" to disconnect as everything else, since the terminals are actually screwed together. I considered getting some waterproof connectors to make it more of a plug/unplug (not that it's a big deal either way).


Edited by: Joe E

 

[Joe E]

Ok, spent some time in the cab this evening, and I think I'm going to velcro it just to the upper left of the stereo, in a triangle shaped flat area. Accessible, not in clear site (near the left window), etc. I'll run the wire down the side of the center bezel, across the top of the tilt wheel, and out the left side. Should be fairly clean.


The Attitude is really nice, but not very well designed for "neat" packaging, IMO. The wire location (out the bottom) and shortness doesn't help...