Diesel Place banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,715 Posts
Discussion Starter #1
splice a few wires and cuss some and here's what you get
 

·
Registered
Joined
·
267 Posts
Dave, you do know that Edge is coming out with a 3' extension any day now, right? Would have prevented some of the cussing...



I'm getting a replacement panel from Eric, and going to trim mine out to fit the Attitude there, but include the panel (not sure if you just hadn't finished, or were going to leave it like that.


Either way, how do you like it mounted there as far as vision and being able to see it from an angle? I was going to tilt mine a little towards the driver, but it'll look goofy if I rotate it too much.


Edit: Ps, like the black face on the Atitude.Edited by: Joe E
 

·
Registered
Joined
·
61 Posts
Nice. I'd sure like to read a description of how you painted the Attitude. Did you operate on it? Mask carefully and pray a lot?
 

·
Registered
Joined
·
1,715 Posts
Discussion Starter #4
ordered a cover from aaron......comes apart easy 5 screws
the extension is a ways off could not wait any longer....easy to paint disasembles into four pieces...dave

recessed a piece of black abs plastic the factory cover made it stick out to far and hard to seeEdited by: sdaver
 
1 - 4 of 4 Posts
Top