Diesel Place banner
1 - 7 of 7 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 2005 GMC 2500 Duramax Crew Cab pickup. Lately, whenever I put the truck in reverse, the line under the R will blink and the message center says "shift range inhibited". I've taken the truck to my dealer and they replaced the switch in the steering column. Brought it home and in a couple of days, same thing, no reverse. If I put it into drive, it slams. Took it back and they replaced the transmission control module. After a few more days, same thing. Now the truck is in the garage for another major part change. Has anyone ever had this problem? Sure glad this is happening in the winter. I'd really be mad during camping season and towing. Any thoughts would be appreciated. My dealer doesn't know what to do and GM wants to try all of these parts before they replace a transmission. That hasn't been talked about yet, but I'm getting to the point where I'm going to suggest it real quick.
 

· Registered
Joined
·
1,356 Posts
Did they even look at the NSBU switch on the drivers's side of the trans near the pan?

DEWFPO
 

· Registered
Joined
·
472 Posts
fluid level low?
 

· Registered
Joined
·
393 Posts
I have a 2007 with just over 1000 miles on it doing the same thing. Not every time and it doesn't slam into drive. Several here mentioned that it could be my Edge Juice causing the problem.

Good luck
 

· Registered
Joined
·
1,251 Posts
03LB-7dmax;1556979; said:
I vote for N.S.B.U. Switch.
I'll second that...
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top