Diesel Place banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
534 Posts
Discussion Starter #1
Can anyone tell me if the hole (about .156") found in the 3/4 frictions are intended for alignment during installation. Thank you.
 

·
Registered
Joined
·
534 Posts
Discussion Starter #5
There is a hole in the C3/4 frictions (not the oil slots). I know about the 12 o'clock piston hole, take a close look at a friction and you'll see what I mean. Can only think it's for aligning the frictions on the ring gears??? What do you think?
 

·
Registered
Joined
·
704 Posts
Put a line on the sun gear with a marker, then put each friction on lining it up with the mark. This way you can align each friction without being able to see the ones below it. Also remember to line up the steels.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top