Diesel Place banner

1 - 3 of 3 Posts

·
Registered
Joined
·
123 Posts
Discussion Starter #1
I just installed my new Juice/Attitude and (EGT) thermocouple. Will admit was a little nervous about tapping and drilling the cast iron exhaust manifold after reading the thread by Leo(CntrlCaldmax) with his troubles. All went very good though. I did tap it a little deeper than I intended too, had to run the fitting all the way in to get it to tighten. As old and blind as I am it's lucky it turn out as well.


I want to thank all on the Diesel Place for the information that helps us to be able to do these projects.


Ridge Runner
 

·
Registered
Joined
·
6,063 Posts
yes eric you're right.. i've done a few and get less nervous each time...
 
1 - 3 of 3 Posts
Top