Diesel Place banner
1 - 5 of 5 Posts

·
Registered
Joined
·
171 Posts
Discussion Starter · #1 ·
Well I just got doing finishing the front install of my Cognito 4 inch lift. It has taken me forever and alot of work. Now my question-----Once on the ground, both front wheels are ****ed out. So if you are looking at it from the front, both wheels are sticking out toward the outside edge. Up and down they seem good. Did I do something wrong??? or is this normal after an install? I know I need to get it aligned but I can not really drive it like this so what do I do now???
 

·
Registered
Joined
·
13,596 Posts
Get a tape measure and measure in front and in back of the tires and adjust your tie rods until you get the measurement real close.Then you can drive it to an alignment shop.
 

·
Registered
Joined
·
426 Posts
what he said.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top