Diesel Place banner

1 - 6 of 6 Posts

·
Registered
Joined
·
110 Posts
Discussion Starter #1
I am adding airbags with a controller and compressor, and wanted to know where i can tie into the accessory wire? does it have to be strong enough to support the compressor?
 

·
Registered
Joined
·
825 Posts
What are you adding them to?
 

·
Registered
Joined
·
825 Posts
You can tie it into an empty space in the fuse panel. There is an accessory one in the fuse panel in the driver's side door jam. I forget which fuse it is, though.
 

·
Registered
Joined
·
110 Posts
Discussion Starter #6
If you want to tie in under the dash see post #10 in this thread:

http://dieselplace.com/forum/showthread.php?t=52245

The info is for an '03 but I don't think it's changed since then. You can verify with a multimeter or test light, just be careful to not accidentally short anything out while probing around.
Thanks, I never even thought about tapping into the trailer brake harness, which will be the easiest. Thanks alot, you save me alot of time.:cool2:
 
1 - 6 of 6 Posts
Top