Diesel Place banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,718 Posts
Discussion Starter · #1 ·
I just received my AutoMeter Ultra-Lite gauges and 3 pod A-Pilar mount. I just did a dry fit on the A-Pilar mount and it fits perfect, almost too perfect. I don't see anywhere to run the wires out of the bottom.

Any tips? Pics if you have them.

Thanks,
Dave
 

·
Commissioner Gordon
Joined
·
5,141 Posts
I drilled 2 holes in the factory pillar (one up high one low) and cut from end to end of each hole to make plenty of room to get as much wiggle room for the wires as possible. But then I do have 4 switches wired into my lowest pod (see garage).

You have to drill holes to mount the pod to the pillar, so you might as well destroy the rest of the pillar. New pillar isn't too expensive when it's time to go back to stock.
 

·
Registered
Joined
·
1,386 Posts
I've only got a two pod, but I was able to somehow slip the wiring between the dash and the factory pillar base, then slid the pod pillar into the same crevis. I do have an electronic boost though.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top