Diesel Place banner
1 - 1 of 1 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
The rear axle on my truck is a dual wheel. The Yoke opening is larger than my driveshaft for the U-Joint. I got a 331 joint to put in it, and it fits perfect in the driveshaft, but the yoke has about 3/16" play side to side. The Diamater of the bearing cups is correct, but the width is two narrow. Does this sound familiar, or does anybody think that my yoke is worn?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.