Diesel Place banner
1 - 5 of 5 Posts

·
Registered
Joined
·
102 Posts
Discussion Starter · #1 ·
I was wonderin if I would shove some 37" TOYOs on with a 6" RCD lift kit without too much rubbing? My friend runs 37s on a 6" lift but he has an LMM. I don't mind if there's a little rub but with my setup now I rub just backing out of the driveway.
 

·
Registered
Joined
·
848 Posts
It will rub, for sure. The front bumper is easy enough to trim up, but the back of the fender isn't quite as easy. That's where it will hit more. One variable is the width of the wheel you use, but it will rub for sure.
 

·
Registered
Joined
·
3,137 Posts
i have a 6" RCD with 37"s and i rub when i turn full lock backing up and at full lock and i hit a large bump but i think if i get some time this weekend to work on it a little i will get that fixed but it is do able you may look into some cut outs or you can try to trim the rear and see if you can keep the factory flare
 

·
Registered
Joined
·
116 Posts
I have a 6" RCD with 37" Pro Comp X-Terrains on 17 x 10 wheels. I have done some trimming to my fenders and have some Cognito extras on my front end. My truck doesn't rub at all. Good luck!
 
1 - 5 of 5 Posts
Top