[Ben46a]

All the 5" mbrp i see listed are for EC/CC trucks. Will they work on an RC truck as well with just cutting? or will bending be required too?

 

[DMAXBOB]

I don't know about MBRP but I pm the Magnaflow Rep and he said he would check with the design team or whatever (its been a while with no reply) for measurements but he did say that he did not think the hangers would line up. I imagine that since the WB of the ec/cc trucks are longer, you could proably section out whatever excess pipe and just cut and reweld the hangers.

DMAXBOB

 

[MBRP Tech]

MBRP 5" system

All the 5" mbrp i see listed are for EC/CC trucks. Will they work on an RC truck as well with just cutting? or will bending be required too?

Ben46a and DMAXBOB,

If you are looking at a 5" cat back for a reg cab Dura the EC/CC kit will not work. The only set up that will work for the reg cab is the "off road" downpipe back that deletes the cat. The part number is S6020AL and will work on 01-07 classic trucks. This set up is for all applications so all you will have to trim is the extension pipe. The rest bolted up to the factory locations.

I'm sure if you contact any of the supporting vendors on this site they will for sure help you out with some pricing.