Diesel Place banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 1998 K3500 that will shift fine on the first time through, but will then hang in limp mode after the first stop. If the ignition is switched to the off postion for 6 seconds and the motor is restarted, it will shift normally again one time. I have replace both the input and the output sensors, and the problem still remains. Is there another sensor or conection that could be causing this problem?

thanks
 
1 - 1 of 1 Posts
Top