Diesel Place banner

4" cat back MBRP exhaust install,lift?

665 Views 3 Replies 4 Participants Last post by  DSTRBD
Hi
Just received my 4" cat back exhaust from Performance Truck Products, (Thanks NAte!) . I noticed my existing system is one piece from cat back. I can cut the old system to remove, But, do I need a lift to install the new system? I do not have access to a lift. I have tools in hand and ready to install

Thanks
Ron
Status
Not open for further replies.
1 - 4 of 4 Posts
Using a sawzall, a cut after and before the muffler, and behind the transmission. The stock should drop right out. I don't think you need a lift for the exhaust but the lift would be a whole lot easier with one.
Right, lift not needed.
What they said! If you want to pull it out in one piece however, you will need a jack.
1 - 4 of 4 Posts
Status
Not open for further replies.
Top