I spun a bearing in my 2011 a few days ago. 294k miles and 12k+ hours on original motor. Can anyone recommend a good turnkey shop in the Houston area to remove/reinstall and rebuild? I’ve been looking into Thunderbolt but am reading mixed reviews. I don’t have the time right now to pull the...

Anyone have a line on good repair/rebuild shops for Duramax FICMs? Turns out mine is failing and needs a rebuild or replacement… less than happy over here.

Hi thanks for all your help first As a Brit I have got 6.5 engine destroyed the turbo had been cut off so it’s got no tif o so I got a secondhand one and said about renewing the seal so I got kit and strip her down . So got to undoing the 3 screw I remove the bearing at the other end and this...

I have an '88 K2500 with the banks turbo (pretty sure it came from the dealer that way, though not entirely sure. I bought the pickup in '96, replaced the transmission in '98 and then in '01 parked it after the transmission died (this time it was my fault, the dipstick was going too far down...

Please tell me about the 4L80Etransmission of my 1994y GMC SUBURBAN 6.5 DIESEL. My SUBURBAN lost reverse gear and rebuilt the transmission. I put that transmission in my car, and I drove it, and all the gears switched normally. However, manually switch to the 2nd gear and pull out the...

Anybody see a step by step instruction on a GM Turbo rebuild? Mines in need of one. I'm also pretty sure I'll need new vanes, intake & exhaust, since the turbo wore out enough that both sides have contacted the housing. I've seen kits but no place to get other parts:(