Diesel Place banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. 6.5L Diesel Engine
    I have a 1993 6.5 (DB2 IP). It had been sitting for a while when I got it, probably about a year. This has been a coastal truck and I do live on the coast. Other wise reasonably maintained from 1st owner at 100k miles. I've put 260 miles on it, and in the last 20 or so I've had the truck...
  2. 6.5L Diesel Engine
    Hello. 1. I just adjusted my DB2 fuel pump (1/8 turn in). Seems to run great, but haven't road tested yet. I did notice immediately that my idle speed went up a bit. Turning the adjustment screw on the throttle linkage does not change it. Apparently, the screw in not making contact with...
  3. 6.5L Diesel Engine
    I have a 1993 Chevy 3500 SRA and have recently rebuilt the engine. The front of my injection pump is loose and I'm not sure if I'd be better off to rebuild the pump or buy a new or remaned pump. Its the mechanical pump (DB2 I think) NOT the electronic with the PMD. Looking for suggestions on...
  4. 6.5L Diesel Engine
    Cold tired grease monkey in need of help. I am attempting a DB4 to DB2 injection pump swap for my 6.5l, and it's currently sitting at no-start, and I'm suspecting the pump I got is bad. I picked up a used DB2 injection pump, person I bought it from said it was from a truck that broke the crank...
  5. 6.5L Diesel Engine
    A fellow 6.5 has a 96 2500 and has had to replace 8 Injection pumps this year. They have all been remand by a shop in his local area. My question is he is looking for a reliable reman shop to purchase a good built IP?
  6. 6.2L Diesel Engine
    Hello friends! First post, but I have been lurking this website for over a year now. I will try to keep this post as short as I can but we'll see! First, a little about the truck - 89 K2500 with a late 80s 6.2 J code that I swapped from a motorhome (I know right) in June of this year. Motor has...
  7. 6.5L Diesel Engine
    I have a 6.5 engine with a DB4 pump I want to install in a Suburban which had a 6.2l originally. Since I do not have a way to use the DB4 injection pump in my truck I wish to use the DB2 pump I have but the injection lines won't fit and what I would like to know is if injection lines from a...
  8. 6.5L Diesel Engine
    Hello everyone I am new here, I have a problem with a 1993 Chevy 6.5 turbo diesel. It does not have the p.m. d-box but it does have something bolted on the mechanical pump that plugs into top of the pump. It gets warm and it will not start I have to wait till it cools down enough for the glow...
  9. 6.5L Diesel Engine
    I'm getting ready to convert my 97' manual K2500 to a DB2. I have a line set, a 4911 IP, and a pedal setup for a throttle cable. I know that I'm going to have to fabricate a cable bracket for the IP and I know how to wire up everything for the DB2 but I not sure what I need to do with all the...
  10. 6.2L Diesel Engine
    where to get them? i have been reading and reading and im almost certain i can rebuild a pump with the tools i have. as for making a clean room for rebuilding it i was thinking of closing a section of my buddies garage (hes a clean freak so its semi clean) off with plastic and having air...
  11. 6.2L Diesel Engine
    This should be a fairly easy question: There are two connectors on top of the the injection pump - one closer to the radiator and one closer to the intake. Which one is the shutoff solenoid? I'm in the middle of a swap and am not sure which wire was pink and which one was green.
1-11 of 11 Results
Top