Diesel Place : Chevrolet and GMC Diesel Truck Forums - View Single Post - mech wastegate step x step with pics
View Single Post
Old 03-15-2006, 05:44 PM   #6 (permalink)
dvdmacdaddy
Diesel Fanatic
 
dvdmacdaddy's Avatar
 
Join Date: Jan 2006
Location: Texas Tech
Posts: 129

I bought a 3ft piece of 1/4 round bar (like all thread with out the threads), 2 washers, a clip ring, a compression spring, and a stop washer. Cut the bar to desired length, bent one end to a 90 degree, then threaded boths ends. Built a repleca of the vacume bracket out of 1/8in steel. Installed the bent end through the old hole and stuck the clip ring on it. Then installed the bracket with the rod running through the hole. Ran a washer down the rod put the spring on put the other washer on and put the nut on.
Attached Images
File Type: jpg homemade_turbo_master.JPG (24.5 KB, 2701 views)
__________________

98 GMC K2500 ECSB 6.5TD, F VIN, 3.73, 4l80e trans, #9 Resistor, FSD Cooler, AC Delco 60g glow plugs, 4in exhaust w/ 3in down pipe, Wester ECM re-flash, homemade TM or stock wastegate (which ever I feel like using), Bully Dog Trans/Boost/EGT gauges, D-Max fan & clutch, Water/Methanol Injection 15% meth/85% water, Marine Injectors

Crossing fingers I get an IC for X-Mas!! That would be sweet.

"Taste death, live life."
"If it is s that important it wouldn't fall off that easy."
"I don't know what this is or where it came from but it looks important."
Offline   Reply With Quote