Diesel Place : Chevrolet and GMC Diesel Truck Forums - View Single Post - LB7 Throwing P1093 Fuel Rail Pressure Low during power enrichment
View Single Post
Old 08-23-2019, 10:00 AM   #3 (permalink)
Block Heater
rickbat's Avatar
Join Date: Aug 2019
Location: Export PA
Posts: 17

Thank you for the reply!

I'm going to pickup some 1/2 clear tubing and look into setting the rail pressure at idle to 21000 psi. Need to figure out where to command that in autoenginuty cant be to hard to do im sure.

The truck throws the code every time you put the pedal to the floor and make it try to take off. If you try this from a dead stop on a steep grade the truck just sits in place wont move or build rail pressure.

I ran the injector balance test on all 8. They all showed between + or - 2. It sits and idles perfectly not much smoke from tailpipe ever. A friend also told me try to run the contribution test on the injectors.

Will keep you posted...
Offline   Reply With Quote