Diesel Place : Chevrolet and GMC Diesel Truck Forums - View Single Post - Crank no start after engine replacement
View Single Post
Old 08-13-2019, 07:26 PM   #6 (permalink)
Aftermath2014
Low Boost
 
Aftermath2014's Avatar
 
Join Date: Aug 2019
Posts: 7

Quote:
Originally Posted by sfcjones View Post
to prime the fuel just press the primer pump located on your fuel filter housing. On top of the housing is a bleed screw. loosen it and prime until fuel bubbles out. It might take about 40 pumps to achieve this. Let us know if this works.
I have a good prime and its priming fine. I even removed the filter to make sure it was full of fuel. I put it back on and primed it again. the problem is fuel pressure on the high side. Everything is new on a run tested engine. I loosened a highpressure line and cranked it over, but fuel barely came out.
__________________
2006 Chevrolet C5500 Kodiak
6.6L Duramax
Allison transmission
Duramax tuner w/optimized factory tune
Offline   Reply With Quote