- 6.2L Diesel Engine
- - 700r4 tv problem?
||02-20-2013 09:34 AM
700r4 tv problem?
I just rebuilt my 700r4 in my 89 and im having a problem with the tv cable setting. Ive set plenty of them and never had a problem until this one. I bought a new tv cable from the dealer and did the factory setting and i had soft shifts at light throttle but good shifts at heavy throttle. So i pulled the pan and its pushing the plunger all the way in at full throttle but its releasing it all the way at idle. From all the transmissions ive ever done and from the people ive talked to i know there is suppose to be a small amount of preload on the plunger at idle. Ive looked for longer springs but havent found any so i bought a longer one and put it in and now it shifts good but the spring is to stiff and i also notice that if im going from reverse to drive and the truck is rolling even a little back it will make the tv plunger stick and not move until i stop and shut the truck off and start again. When it does stick like this it shifts kind of late and firm and theres no downshifting when you step on the throttle. Im assuming it sticking because the throttle gets really hard to push and it feels like its just compressing the tv spring. Anyone have any ideas about this?
||02-20-2013 05:08 PM
Sound like the cable sweep at the throttle side is to l
||02-20-2013 05:13 PM
Sound like the cable sweep is to long on the throttle side of the cable. You might need to change the radius so the cable doesn't move as far. I had same issues when switching from Tbi to carb. Hope that makes sense.
|All times are GMT -4. The time now is 03:48 AM.
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
vBulletin Security provided by
vBSecurity v2.2.2 (Pro) -
vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by
vBShout v6.2.1 (Lite) -
vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.