Advice on replacing 4in straight pipe with stack
Im replacing my 4in straight pipe on my LBZ Duramax with a smoke stack. Iím leaving the 4 in from down pipe to my new 5in stack. My real question is, how big should I make the hole in the bed for the stack? The stack is 5in Inlet to 8in outlet. So Iím wondering if, instead of making a 5 in hole in the bed, should I make one slightly bigger than 5in? And do Iím wondering if I need to fabricate some sort of 5in rubber seal to go between the stack and the hole in the bed, to eliminate vibration from the stack. Iím assuming the stack would rattle and vibrate the metal bed. Help!
|All times are GMT -4. The time now is 03:05 PM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.1 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.