Diesel Place banner

Labonte DIS-S3 question

1K views 7 replies 4 participants last post by  hogstroker 
#1 ·
I am looking into buying a water/meth system and I had a question about the DIS-S3 system that I hope someone running it can answer.

Where/how does it get it's signal for duty cycle of the injectors? I was curious as to how this was wired in? Through the obd2 port? I'm not keen on splicing into my wiring harness if this is required-especially the injector circuit.

Thanks in advance!
 
#2 ·
It splices in on one of the number two injector wires. Don't worry, its easy to get to and splicing its easy as well.
 
#5 ·
I'm from Red Deer and I would definetly like to look at your system. Looking at your details, I am guessing you are an overseas oilfield guy as well huh? Are you around in July? I get home on the 2nd of July and would really like to check that set-up out.

PM me your ph# and I can give you a shout when I get home.
 
#7 ·
The kind that looks like you're sticking a needle through the middle of the wire.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top