Has anyone been able to verify if the existing SoCal Attitude Overhead gauge mount will work with the Edge Attitude LBZ unit? I know their was a mention of different size in another thread here.


http://www.socaldiesel.com/Attitude.htm

I would think that it would, I used a mount form ATS that I had lying around and it worked perfect:)

I went by yesterday with my BETA unit and Trippin and I tried it with the new unit. It fits perfect into the SoCal Diesel Mount. So I picked one up while I was there.

Does anyone know which mount is needed for the sunroof overhead console? My unit looks different. I have switches for the homelink/sunroof.

Does anyone know which mount is needed for the sunroof overhead console? My unit looks different. I have switches for the homelink/sunroof.

I picked up a suburban over-head console to replace the one in my truck. These are perfect because they have the sunroof/homeline buttons but also have a large opening for the mount ;)



-- Rick

Riccas- thanks. Guess ill have to go searching for the overhead mount.

Riccas- thanks. Guess ill have to go searching for the overhead mount.

The opening on the sunroof version only measures 1.25" vs 2.5" on the non-sunroof models.

Without surgery I'm not sure how you would get 2/16" gauges to fit.:confused:

The opening on the sunroof version only measures 1.25" vs 2.5" on the non-sunroof models.

Without surgery I'm not sure how you would get 2/16" gauges to fit.:confused:

Correct there is no way for gauges to fit :( I have the same problem, I don't know where I'm going to put gauges since I don't like the a-pillar in Casper.

I picked up a suburban over-head console to replace the one in my truck. These are perfect because they have the sunroof/homeline buttons but also have a large opening for the mount ;)



-- Rick

I might have to try that. Thanks for the tip :D