I gotta ?.can i install the Superchips programmer in my truck.an put my edge box module.under my hood at the same time.will everything work right and stuff.i really wana try it now.wil the ecm an computer an stuff be alrite? i'd appreacate a feed bak.

moved to the correct forum.
may help get an answer.

Yes, this is called stacking!

How do i install them both?

Well remove the edge completely from the truck. Set up the superchips for install on whatever level you want to run it. Install it, then hook the edge back up and run on a level so that you are technically less than 100hp over stock limit. You will limp the transmission otherwise. Good luck.

ok lol it doesnt **** that wel now.is there anything that i can do with the chips to make it shift better.it like seems like im ridin in a manual shift.

The trans. may just need to relearn to shift correctly for the power change.

C-ya

Allision trans trucks will need a learning after any reporgramming. Usually takes 25-30miles of easy driving with no hard starts, accelorations. The trans will learn the extra power very well and should shift properly unless there is to much power and then you come up with a LIMP mode from the trans computer.
I hope this helps.
Ron

Just to expand further on the above. Driving 25-30 miles on the highway will do nothing for you. You need to drive it in such a way that it upshifts and downshifts. The Allison TCM will make an adjustment to the shift pattern based on what the trans actually does and what the trans programming is calling for.