PEANUTGRWR
08-07-2006, 12:15 AM
Are There Any Plans To Have An Allison Logging Function. To Log All Tranny Functions?
|
Elowe65 08-07-2006, 01:10 AM You can do that now. Open scan, go to Edit->Properties->Under connection->tab top right corner where Controller ID->Select $18TCM->click OK->Turn Ignition ON->Press the green button to connect to TCM and go select your PIDS to log Listed below are a few things that can be logged; Current Gear GM.GEAR Delivered Engine Torque to Transmission GM.TRQENG_B Driver Demand Engine Torque GM.DDTRQ Off-Going Clutch Pressure GM.OFFCLUTCH On-Coming Clutch Pressure GM.ONCLUTCH Requested Torque Reduction REQTRQR GM.REQTRQR Selected Gear GM.GEARSEL Throttle Position GM.TP Torque Converter Clutch Duty Cycle GM.TCCDC Transmission Converter Clutch Slip Speed GM.TCCSLIP Transmission Fluid Temperature GM.TFT Transmission Input Speed GM.TIS Transmission Output Speed GM.TOS Turbine Speed GM.TURBINE Flashscan 08-07-2006, 01:16 AM Paul plans to get into the next release something that will be nicer than selecting the module you wish to log via that menu. The plan is when you connect to the vehicle EFILive will prompt you with a list of the modules detected and you then choose which one you wish to log (assuming we support the data streams for the module). Currently it's too easy to forget what you have the module set to in the menu because it is hidden. Trust me, I've stared at the screen wondering why it would not validate any engine PID's only to realise it was set to log from module $18 (TCM). Cheers, Ross PEANUTGRWR 08-07-2006, 09:27 AM Thanks For The Help Guys, I Appreciate It PEANUTGRWR 08-07-2006, 11:04 AM i tried it and the pid's stayed the same as for the engine and said that it was out of range when i tried to view/record data. none of the pids you listed above were avail on the list wsucowboy 08-07-2006, 11:46 AM good info! -Jeff Elowe65 08-07-2006, 01:57 PM i tried it and the pid's stayed the same as for the engine and said that it was out of range when i tried to view/record data. none of the pids you listed above were avail on the list It's been a while since I've done it so forgive me, I believe you will have to validate the PIDs on the TCM (since it's the first time), just like you did on the ECM, before you can select them and log. | ||