well guys i'm doing the cst spindle lift and i got 1 side done but my problem is am i supposed to flip the tierod over to go through the top instead of going throught the bottom like it was on the stock spindle any help will be greatly appreciated and thanks

What can't u do?


Loosen the lock nut on tierod and turn the outer tierod.


It's going to need aligned afterward anyway.

No you put it back together just how you took it apart. The tie rod ends go in from under just like you took them off. Then you will need to take it and get an alignment after you put it back together.

well thanks guys i just looked at the spindle a little closer and it's tapered from the top so it goes throught the top

Yes the CST spindle tapers the tie-rods from the top down to allow for better tie-rod angles.

you need to adjust each side in 2.5 turns , thats what my rcd instructions say. Edited by: wolfclan

thanks guys i appreciatte the help i'll get some pics up tonight ,now my 35's look to smallhttp://www.dieselplace.com/forum/smileys/Big Smile.gif