I am an electronic hick when it comes to these new vehicles.

This weekends project is to install a set of factory GM fog lamps. I have gone over the instructions and the last section is ( Programming the Body Control (TBC) Module).

1)The TBC must be programmed to recognize the installed for lamps.

2)Use the Service Programming System (SPS) to program the (TBC) as you would any other control module: Body Control Module,(BCM). Power Control Module (PCM), etc. When programming the (TBC), select the calibration for vehicles with for lamps. ( Is there enough achronyms in there or what I started laughing. )http://www.dieselplace.com/forum/smileys/HiHi.gif

3)Connect the service tool to the Data Link Controller (DLC).

4) Program the (TBC) to interface with the fog lamps.

My question is can this only be done at the stealer and what do you think the est $cost will be, if so.

Thx
Bruce Edited by: ntnbolt1

The dealer will have to do that for you. They SHOULD charge you nothing if they have any sense at all.

The lights worked on my 2004 without reprogramming, just FYI.

Ditto my '03.

Mine worked fine when I installled them on my 2004. Did not have to program the DIC.

Can someone come and install my fog lights? I got them from Eric like 4 months ago. I'll provide the pizza and drinks.

If I could I would man. Nice pic's of your truck.