Hey anybody else had trouble getting the DSP boost table to function:( . If I key up and start with the DSP option the boost works:) and the numbers follow the calibration. However if I switch to non-DSP to DSP on the fly the boost doesn't seem to work as the turbo vanes off idle just remain completely open and I set a under boost diagnostic code?:rolleyes:

Truck is 04.5 LLY and I used the 04166801 DSP OS. And I am running the EFILive 467 build.

Thanks,
Todd

Basically if what you are saying is you start in DSP2 mode and then switch to normal and then back to DSP2 mode and then have trouble with boost?

I'll have to try that.

Have not had any reports of that yet, so I guess we can only see what others say.

Cheers,
Ross

Mine works fine.

Mine works fine.

don't have any problem with mine either. Switches just fine and tracks the tunes loaded.

Anyone care to try Todd's tune?

Cheers,
Ross

Sure, I will try anything. What can it hurt? I already killed 1 ECM ):h

Back from vacation, didn't have net connection. The problem was I had started using the DSP2 swith. The Boost table for DSP2 was kPa and I was coping PSI into it. Now I have the table units matched no more trouble.

Thanks All.