I have seen several posts related to guage sets, but none (that I could find) comparing what they actually look like. I have seen two kits, the Isspro kit and the Banks kit. I believe both have the short and long pillar cover and both kids have either 2 or 3 guages (3 gauges not support in the short pillar cover).


I am interested in the 2 gauge setup but not sure if I want the short or long pillar cover. Can someone posts some pictures (or links) showing the differences between the two? I would also like to see what the Isspro look like compared with the Banks setup.


Thanks,


Tim

Might want to check with Mackin ... he used to have pictures of his setup ... Jim

On my WWW, I have the three pod setup with Isspro EV gauges.


Can send you some more close up shots, if you would like drop me a PM.

Here are my EV series gauges.


http://pic8.picturetrail.com/VOL227/437876/551338/10798593.jpg


http://pic8.picturetrail.com/VOL227/437876/551338/10798589.jpg


http://pic8.picturetrail.com/VOL227/437876/551338/10798584.jpgEdited by: Maverick

Maverick


Where did you get them, did you drill the manifold


Geno


thought you were going to end up down south, just could not resist the cold huh.

Geno, I got my stuff from Kennedy. Yes I drilled the pass. manifold.


I did go to NC and came back up here. This is a layover for awhile i guess.

Finally completed the article......

Thermocouple install (http://www.dieselplace.com/forum/forum_posts.asp?TID=946&PN=1)

See my SIG for gauge PICS ,,





Mac