So when replacing the vac lines did you go buy the factory replcement plastic lines or can you just run some new hoses. I cannot imagine it matters much but figured I would double check.

Thanks
Anyone know what size those hoses are off hand?

I would buy the factory tubes, rubber hoses could be used, but be very careful with the routing to keep them from melting or kinking.

I agree with Benjamin. Someone here did theirs recently and I think the whole set was around $40 iirc.

i went with OEM lines {dealer callout references as 'harness'} i bought from J.Kennedy; i installed anti-chafing material to forestall recurrent failures.