Hello all,

I remember reading a thread where some gentleman
was going to make some spacers for his tube steps
because they were too close to the cab. I can't
find that thread anywhere. SO, I happen to have
that same opinion, I like the full-length GM tube
step, but I think it would be better if it were
lower by 1" and further out by about 1". Just
seems like it'd be more useable - to me anyway...

Does anyone know if there's any spacer kits that
might fit the bill?

Thanks!

T.

http://dieselplace.com/forum/forum_posts.asp?TID=7444

http://dieselplace.com/forum/forum_posts.asp?TID=7444

Thank you! I appreciate it.

I just knew I wasn't going nuts - not yet
anyway....http://www.dieselplace.com/forum/smileys/Embarrased.gif

later,

T.