Ok dumb question. I put my juice box and attitude monitor in tonight and have not had time to put the sensor in. What is the point of that? I thought it was for measuring EGT temps? But the attituide is already reporting some EGT Temp readings. Can someone enlighten the stupid.





Thanks,



David

The attitude will give a very low EGT reading when the sensor is not hooked up. When it is hooked up you will see around 250-300 degrees at idle. Right now your probable seeing around 60 degrees IIRC.

You will want to monitor EGT's while towing ... When hooking up the probe you will be able to use the back down feature ,,, This will eliminate or allow you to set max sustained EGT's ...





mac

Also, if you are running the higher levels of tuning from the edge, and pushing the truck hard, you can cause the EGTs to get at a dangerous level. The Edge product will back down the fuel when the EGTs get around 1350.


So, if you are going to tow or are going to hot rod the truck around town on level 5, be aware that you could run hot and damage your pistons.


Running at level 2 around town should be fine, even level 3. If all you are doing is normal driving. Eitherway, I'd put the probe in on the passengers side when you get a chance. It took me about 30 minutes to do mine.

Another question: If you remove the juice/attitude will it set any codes? Do you have to do a certain sequence or anything? Thanks.

Another question: If you remove the juice/attitude will it set any codes? Do you have to do a certain sequence or anything? Thanks.

Should not be any problem disconecting from truck while parked and off of course ....

Mac

Okay another one: Say you want to take out just the attitude by simply unpluging it because of hot or cold weather. Does the box default to a certain power without the attitude? Thanks.