How is everyone getting their cable from the cab to the juice box?


The Attitude manual says to route thru the door/hood hinge.


http://dieselplace.com/forum/smileys/Question.gifEdited by: Blinky

through the firewall. You can run it through an existing grommet or drill a new hole and seal it.

Thanks Max...

firewall.......

I ran mine like the instructions say. May go through the firewall later.

poped a whole in the gromet that the hood release cable goes threw.

I ran mine through the firewall in the wiring harness grommet and had significant interference problems (no start/no run). I have it run through the door jamb/fender and have had no problems in that configuration. I don't know if it was an issue with the wiring harness or the Isspro amp for my EGT gauge that's under there - but I couldn't get it to work through the firewall. (NOTE: some folks have experienced CB radio and cellphone interference issues with the Attitude also.)

I went the door/hinge route also used some wire ties to help protect it from binding.





I can have the attitude/juice combo out in 5 minutes if it needs to go back to the dealer.