My DSP2 switch showed up yesterday I just wanted to say thanks. I just have on question though why is there 2 wires for the ECM? Is it just in case one pole in the switch gets worn out?
Thanks Robert

My DSP2 switch showed up yesterday I just wanted to say thanks. I just have on question though why is there 2 wires for the ECM? Is it just in case one pole in the switch gets worn out?
Thanks Robert

I had the switches made universal for both LLY and LB7.
So the blue wire would hook into pin #31 in the blue connector of the LB7 ECM or the black wire for pin #1 in the black connector on the LLY ECM.

So, one could cut off the "unused" wire and pin and use it for the DSP2 "enable" wire?

Rats! I just remembered that the LLY and LB7 pins are different! Darn!

So, one could cut off the "unused" wire and pin and use it for the DSP2 "enable" wire?

No, One wire is for LB7 and for LLY.